![]() To install the HRN-CW03K3 kit with a GO6 device, tape off the ignition wire and do not connect. ✱ NOTE : The red and yellow wires must connect to a fused source, or the user must install the fuses. RED - T he constant power (12V or 24V) wire which must be connected to a true battery source (live at all times).YELLOW - The ignition sense wire which must be connected to a true ignition source (live with the key is in both the ON and RUN positions, dead when the key is off).BLACK - The GROUND wire which must be connected to a known good chassis ground.There are three connection wires when using the HRN-CW03 S 3 Harness: Installing the HRN-CW03K3 with a GO 7 or newer Always read and follow all safety information to prevent loss of vehicle control and serious injury. WARNING! Prior to HRN-CW03K3 installation, read and follow Important Safety Information and Limitations of Use, located at the end of the document. Incorrect installation of either the GO device, and/or HRN-CW03K3 can result in loss of vehicle control and serious injury. WARNING! Prior to HRN-CW03K3 installation, read and follow GO device installation instructions ( goo.gl/rkLRiA ) to ensure GO device installation is correct in preparation for HRN-CW03K3 installation. Certified Geotab ® Installer certification or equivalent. Professional Installation Required - Installation of the HRN-CW03K3 requires the installer to have sufficient technical knowledge and expertise for mobile device installation and integration into modern vehicles, i.e. HRN-CW03K3 Specifications and Installation Specific installation instructions are provided below. ![]() ✱ NOTE : The GO6 device does not have an ignition pin and, as a result, behaves in the same manner with a 3-wire installation as with a 2-wire installation. With a wide variety of applications, the fuse kit may help minimize complexity, reduce installation time, and improve safety. The HRN-CW03S3 harness has three wires that connect to power, ground, and ignition. The HRN-CW03K3 kit connects to any vehicle to provide GPS tracking (for GO6 or newer devices), accelerometer data (on Pro and ProPlus plans), and ignition voltage (for GO7 or newer devices). golf carts, generators, older vehicles, etc.) or to track the vehicle without connecting to the vehicle bus (i.e. The HRN-CW03K3 kit is used with a GO device and installed in vehicles or assets where a diagnostic port is not available - due to the age or type of vehicle (i.e. The HRN-CW03K3 kit includes the HRN-CW03S3 harness and a fuse kit. ![]() For the most up-to-date version, please visit: goo.gl/VEvruL ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |